 |
1. Insert coil springs into recesses in
back side of blade - hold in place with hard grease. Place bottom row of blades in position with blade edge down (Toward tool joint box end). Use banding tool to compress blades to body of scraper. |
||
 |
2. Reverse scraper, insert remaining springs and blades, securing this row of blades with steel band also. | ||
 |
3. Fit halves of retaining rings in position to receive studs. | ||
 |
4. Screw studs into retaining ring recesses - tighten
securely with allen wrench. Remove steel bands holding blades. Your scraper is ready to run! |
We recommend complete disassembling, repairing if needed, cleaning, oiling and reassembling after each run for best results and long tool life. Back to Product Information D.M. Best Co.,
Inc. This site is maintained by Directory
One |